Fischer 557783 concrete screw FBS II CP 8x80 30/15 TX hexagonal head Corrosion Protect

Fischer 557783 concrete screw FBS II CP 8x80 30/15 TX hexagonal head Corrosion Protect

Bijzondere kenmerken

• The innovative Corrosion Protect surface coating provides even better corrosion protection compared to hot-dip galvanized surface coating
• The special saw tooth geometry enables fast screwing into the concrete
• ETA approval applies to applications in cracked concrete and seismic categories C1 and C2
• The innovative Corrosion Protect surface coating provides even better protection against corrosion, also proven by salt spray test over 2,000h
• The special saw tooth geometry enables fast screwing into the concrete
• ETA approval applies to applications in cracked concrete and seismic categories C1 and C2
• Cleaning of the drilled hole is not necessary in case of vertical installation (in ceilings and floors) and when using hollow drills. The hole should be drilled 3x the drill diameter deeper for holes drilled into floors
• Het aanbouwdeel kan binnen de goedkeuring tot tweemaal worden losgeschroefd om een vulplaat van max. 10 mm te plaatsen of om het bevestigde onderdeel uit te lijnen en vervolgens de schroef opnieuw vast te draaien
• The three approved anchoring depths allow the concrete screws to be used in a wide range of applications, ensuring excellent flexibility
• The concrete screw FBS II CP US is suitable for through hole mounting.
• Cleaning the drill hole is not necessary for installation in ceilings and floors, and when using hollow drills. For drill holes in floors, drill 3x deeper than the drill diameter
• An impact wrench with a suitable cap is recommended for installation
• Wanneer de schroefkop tegen het montagestuk aan ligt is de schroef correct gemonteerd (optische controle van de montage).

Approved for:

• Beton C20/25 tot C50/60, gescheurd en ongescheurd

Also suitable for:

• Beton C12/15
• Massieve bouwmaterialen
• Metselwerk met hoge dichtheid
• Leuningen
• Consoles/Foot plates
• Metal profiles
• Theses
• Drive protection
• Facades
• Temporary assembly of, for example, construction-related equipment
• Formwork braces

Technische gegevens

• Intake: TX40 / SW 13
• Drilling diameter: 8 [mm]
• Screw-in depth / clamping range: 50 / 30 [mm].
• Screw-in depth/clamping range: 65 / 65 [mm].
• Useful length: 15 [mm]
• Min. borehole depth for through-hole mounting: 90 [mm]
• Screw size: 10.0 x 80 [mm]
• Screw length: 80 [mm]